Current Location:Home > Product Introduction > Product Introduction
Product Introduction
We have the most professional technology, rapid installation and permanent safe and reliable solution , I believe there is always a product is suitable for you.
Installation And System Testing
Fittings and pipe should be kept clean and non-destructive before use.
All pipes and fittings after installation must be pressure tested to ensure system integrity, and then they can be delivered to the final customer.
Chemicals
Precautions on the use of chemicals or other potentially corrosive liquids , please contact our customer service department . The fitting is not recommended for use in explosive gas , gasoline and other fuels or heating systems
Warranty
Although we provide warranty for manufacturing defects or material, the customers need to ensure that fittings and related products are suitable for corresponding application . Must be properly installed according to our recommendations. Compliance with recognized codes of practice and relevant national standards and has been properly maintained .
Technical indicators
工作介质 |
工作压力 |
温度范围 |
水 |
20°C |
10 Bar |
65°C |
7 Bar |
|
Also applies to a vacuum , depending on the pipes, the joints can be used at higher pressure and temperature under certain circumstances Please contact our customer service department for assistance. Note: 1 bar = 0.1 mpa |
The length of the pipe inserted to fittings and the outer diameter corresponding symmetric table
公称外径 |
插入管件长度L1/mm |
标准管材外径dn/mm |
20 |
35 |
20.1±0.1 |
25 |
37 |
25.1±0.1 |
32 |
40 |
32.1±0.1 |
40 |
55 |
40.2±0.1 |
50 |
72 |
50.2±0.1 |
63 |
100 |
63.2±0.1 |